Weed eater rte115c user manual

S Use specified trimmer spool. Make sure spool is properly installed and all parts are securely fastened. Loosen and remove wing nut and bolt from assist handle. Place unit on a flat surface. Page 5: Operation 0. Page 6 See page 2 for warning concerning other cutting devices.

Allow only the tip of the line to make con- tact. To receive full value from the warranty, the operator must maintain unit as instructed in this manual. Stop the unit and disconnect the power source when not in use. Print page 1 Print document 10 pages. Rename the bookmark. Delete bookmark?

Cancel Delete. Delete from my manuals? Weed eater instruction manual trimmer rt, rt 10 pages. Tout d6faut de le faire pourrait entrainer des blessures graves. They can be caught in moving dening appliances, basic safety precautions parts. Ensure Locking the cutting head remains free to rotate and the line is not caught between shield and the motor housing.

Cutting Head Shield Motor Housing Use only a voltage supply as specified Always keep the shield in place when the tool your unit. Keep the line parallel to and above the surfaces being swept and move the tool from side to side. Other sizes Continue feeding line into spool, leaving Print page 1 Print document 10 pages.

Rename the bookmark. Delete bookmark? At the time of publication, the correct part number was listed as According to Weed Eater, it is imperative to use the correct size of line for this trimmer. Improper sizes cause line feed malfunctions and the possibility of serious bodily injury.

The manufacturer also warns against using any other material, such as rope, string or wire, as trimmer line. Clean away dirt and debris around the cutting head and remove the existing spool by holding it in place while unscrewing the cap.

Remove the line guide ring and spool from the shaft, and remove the tape from the top of the new spool. Install the new spool and pull 4 to 6 inches of line through the guide ring. Set the ring on the spool and situate the line into the slot on the ring.