How to install xenon hid

The uses of strobe light kits vary from emergency lighting and emergency vehicle lighting, photography as well as entertainment. Car cus Safety is one of the major issues when you are driving your car. There are several factors that you have to keep in mind in this regard. However, the most important among them is the fact that you must be able to see the place thr Depending on the part of the world where you live, all vehicles need fog lights for better visibility.

Fog is usually common in the temperate regions which experience winter. The fog lights are meant to illuminate the low lying ar It is amazing how small things can have great importance!

Third brake lights, also known as stop lamps, cover your back every time you get your vehicle to the rode. They light up every time you step a brake pedal and le Changing brake lights is not a rocket science.

Everybody with a little tech skills and a screwdriver can do it. In this article we will tell you how to change your brake light bulbs within few easy steps. You will need a set of After opening the box with the set you need to check whether all the components were included. Disconnect the battery of the vehicle. Remove the factory light bulbs. If your headlights have dust caps you need to remove them as well. If the backside of the headlights housing is covered with dust you need to wipe it using the alcohol.

Take the HID bulb out of the protective case, hold the bulb only for the base, if the dust gets on the bulb you need to wipe it off with alcohol. Pass the harness wiring through the dust cap. Insert the HID bulb into the housing and mount it. Connect the wires with the factory headlight wiring harness.

Insert the rubber boot through the hole you have drilled in the dust cap Step 4. Connect the wiring of the bulb with HID ballast. Find the mounting place for the ballast, though it's case is designed to be water and dust resistant you need to find the place which will not be affected by the water. Using a double-side tape or brackets mount the ballast. Check your vehicle fuse, you need to use the one which is rated 20 amperes or higher, if your is rated less you need to replace it.

Connect the battery cables. Time Required 1 - 2 hours. Sections 1. Headlights 7 steps. Flags 1. Member-Contributed Guide An awesome member of our community made this guide. Introduction If you're tired of your halogen headlights or fog lights and want to upgrade to something with a better output, try installing an HID Conversion Kit. Step 1 Headlights. Add a comment. Add Comment Cancel. Step 2. If you go higher than that, the light turns blue at k and at k the light output is more of a purple color.

The problem with the blue and purple light is that the visibility is reduced at that light spectrum. The choice is yours. Note that other than a HID Conversion Kit you may also need electrical tape, a flat screwdriver, and a razor blade.

Start by opening up the hood. Remove the cap from the back of the headlight assembly. To remove the cap from the back of Mercedes-Benz headlight assembley you will need to twist it counter-clockwise.

You may want to wear gloves as you perform this upgrade. The bulb can be easily removed by twisting it a few degrees. Pull out the H7 halogen light bulb. Remove the electrical connector from the headlight and pull the H7 bulb out of the socket. For a clean install, we will insert the ballast inside the headlight. This way we avoid drilling holes to the headlight assembly.

Use a Double Sided Tape such as 3m to place on the bottom of the ballast. Once you do that insert the ballast inside the headlight housing and make sure it is secure. If your ballast gets very hot you could risk damaging the headlight assembly with this method. You could also install the ballast outside the headlight but in that case, you will need to drill holes. You will need to insert the wires through the metal clip that locks the bulb in place. In order to do this you will need to remove the rubber piece.

In our case, we cut out the rubber piece. If you plan on installing the ballast outside the headlight, you will need this rubber piece and will need to drill holes in the headlight assembly.